Multisensor 4in1 AEONLABS EOL

Only change parameters settings on the parent device

This z-wave multisensor acts as the parent device - all configuration changes are made in the parent device.

Important - Dont make changes to the other icons (humidity,light,temperatur=e) as this will result in an error message for that sensor icon (for MiCasaVerde Vera)

Wake-up the MultiSensor if Battery Powered

If the z-wave MultiSensor is being powered from batteries then it will spend most of its time asleep. Like all battery-powered devices it must be awake to accept new configuration settings.

Settings Tab

Device Options Tab

Unusually for VERA, all the common parameters are already populated in the 'Device Options' tab.

USB Powered Settings

The above settings are designed to conserve battery power, by keeping the MultiSensor asleep for as long as possible and only sending temperature, humidity and light reports every 12 minutes (720 seconds).

If you're using USB power you can change these settings to increase the report frequency to as often as you like.

A useful parameter to change when using USB power is 101, which controls the time interval at which updates are sent.

It's a binary combination number made up of the sum of the values for the individual sensors and battery. Each sensor has its own value:

• Temperature - 32
• Humidity - 64
• Light Level - 128
• Battery - 1

When u want all sensors to update their status regurlarly then set parameter 101 to 225 (32 + 64 + 128 + 1).