You have just ordered a nice set of home automation equipment and you want to connect everything. But how do you do that quickly and efficiently? You can of course install them directly where you want them, but you do not always have direct reach with your controller because there is not yet a MESH network build up.
In addition, you must always be close to your PC to check via the interface whether a module has been successfully registered (except for Homey because you do that via the app there). With this ROBB SMARRT test cord you can easily make a test setup with your built-in modules and include them all in your system, after which you then install them where you want them. The MESH will then eventually be built up by your system. So you no longer have to run from the attic to the living room to see if your inclusion is successful, how handy is that? You can use the cord for the products of: